HID HDPii Plus User Guide 2.0 - Manual (Page 37)

HDP5000 & HDPii Card Printer Encoder User Guide_L000950, 2.0
December 2012 Page 37 of 103
© 2012 HID Global Corporation. All rights reserved.
3.8.2 Adjusting the Ribbon Type
Use the Ribbon Type dropdown menu to match Ribbon type.
Step Procedure
1 Adjust to match the Ribbon Type selection with the Ribbon type that is loaded in the Printer.
• YMC (Full Color): Yellow, Magenta, Cyan
OR
YMCK (Full Color/Resin Black): Yellow, Magenta, Cyan, Resin Black
OR
• YMCKK (Full Color/2 Resin Black): Yellow, Magenta, Cyan, Resin Black, Resin Black
OR
• YMCKH (Full Color/Resin Black/Heat Seal): Yellow, Magenta, Cyan, Resin Black, and Heat
Seal
OR
• YMCFK (Full Color/Resin Black/Fluorescing): Yellow, Magenta, Cyan, UV Fluorescing, and
Resin Black
• YMCKI (Full Color/Resin Black/Inhibit): Yellow, Magenta, Cyan, Resin Black, Inhibit
• YMCKHI, (Full Color/Resin Black/Heat Seal/Inhibit): Yellow, Magenta, Cyan, Resin Black, Heat
Seal, Inhibit
• YMCKIKI, (Full Color/Resin Black/ Inhibit/ Resin Black/ Inhibit)
• YMCK Half panel
• YMCKK Half Panel
• K Premium Resin
3.8.3 Adjusting the (InTM) Film Type
Step Procedure
1 Allows you to select the InTM Film type option that is appropriate for the type of InTM Film currently
loaded in the Printer.
• Select the Clear option to automatically adjust the appropriate transfer time and temperature to
pre-determined defaults. ( Note: Select this option to automatically adjust the transfer
temperature and the dwell times to defaults when non-custom card type is chosen on Card tab.)
OR
• Select the Holographic option to change appropriate internal Printer settings needed to make
the holographic InTM Film work. ( Note: Select this option to automatically adjust the transfer
temperature and the dwell times to defaults when non-custom card type is chosen on Card tab.)
• High Durable Clear InTM film
( Note: It will also adjust the necessary transfer temperature and the dwell settings in the Driver to
provide the optimal holographic InTM Film performance.)