13 using the ribbon print supply tension setting, 14 using the film supply transfer tension setting – HID HDPii Plus User Guide 2.0 User Manual
Page 31
HDP5000 & HDPii Card Printer Encoder User Guide_L000950, 2.0
December 2012
Page 31 of 103
© 2012 HID Global Corporation. All rights reserved.
3.7.12 Using the InTM Film Print Take-up Tension Setting
The InTM Film Drive sets the baseline for the Film Tension.
Do not adjust the InTM Film Drive.
3.7.13 Using the Ribbon Print Supply Tension Setting
This procedure controls the tension of the color Ribbon during printing. Adjust the Ribbon tension
if the Ribbon wrinkle is appearing on the card. (
Note: Adjustments moderately change the image
length. “+” Adjustments can eliminate some cases of wrinkle
.)
3.7.14 Using the Film Supply Transfer Tension Setting
Adjustments significantly change image length. Only small adjustments recommended because
of sensitivity. (Note: Adjustments affect flash and smudge.)