2 using the print top of form setting – HID HDPii Plus User Guide 2.0 User Manual
Page 27
HDP5000 & HDPii Card Printer Encoder User Guide_L000950, 2.0
December 2012
Page 27 of 103
© 2012 HID Global Corporation. All rights reserved.
3.7.2 Using the Print Top of Form Setting
From
Advanced Settings, modify the Print Top of Form Setting.
Step
Procedure
1
Verify the Transfer TOF is set to +35.
2
Verify the Print TOF is set to +20.
3
Verify the Print LOF is set to +7.
4
Print the alignment card self-test (the front edge should look like the figure).
5
Adjust the Print TOF until the green border is eliminated and the entire Transfer Alignment Block is shown in
the center of the card.
Note:
Due to variation in roller alignment, the green border may appear at a slight
angle on the top of the card.
6
Verify the entire alignment block is visible and the green has been eliminated from the center of the card.