Sony SU-PW3M - Manual (Page 9)

9
(GB)
2
Adjust the angle of the stabiliser
arms.
When installing the TV perpendicularly (0
degrees), adjustment of the arms angle (step 1
and 2 below) is not necessary. Make sure that
each stabiliser arm is screwed in securely.
1 Remove the screws that are at the top and
bottom center of the both stabiliser arms.
Then choose the notch corresponding to the
desired angle (5, 10, 15 or 20 degrees) and fit
the stabiliser arm to it.
2 Firmly secure each stabiliser arm using the
screws removed in step 1.
Notes
• Be sure to adjust the angles of the right and left
arms to the same angle.
• Be careful not to pinch your fingers when adjusting
the angle of arms.
• When using an electric screwdriver, set the torque
setting to approximately 2 N·m.
Step 3:
Installing the Plate Unit
on the wall
1
Fix the Plate Unit to the wall
using four or more M8 (or
equivalent) screws (not
supplied).
Select at least four screw holes with the same
mark shown in the diagram below, and tighten
the screws securely so that they will not come
loose.
WARNING
• The screws securing the Wall-Mount Bracket to the
wall are not supplied.
• Be sure to use the appropriate screws, depending on
the material and structure of the wall.
• If the Plate Unit cannot be attached securely
enough, use additional screws.
• Be sure to confirm that the Plate Unit is securely
fixed to the wall.
2 1
• 0 degrees: Leave the white screws tightened as they
are.
• Other than 0 degrees: Remove the white screws.
Stabiliser arm
Align the unit so that it is exactly level.
Plate Unit