Sony VPL-PX1 - Manual (Page 10)

10
(GB)
Location and Function of Controls
Control panel
1 I / 1 (on / standby) key
Turns on and off the projector when the projector is in
the standby mode. The ON/STANDBY indicator
lights in green when the power is turned on.
When turning off the power, press the
I / 1 key
twice following the message on the screen, or press
and hold the key for about one second.
For details on steps for turning off the power, see “To turn
off the power” on page 18 (GB).
2 INPUT key
Selects the input signal. Each time you press the key,
the input signal switches between video/audio input
and INPUT A connector.
3 MENU key
Displays the on-screen menu. Press again to clear the
menu.
4 ENTER key
Enters the settings of items in the menu system.
5 RESET key
Resets the value of an item back to its factory preset
value. This key functions when the menu or a setting
item is displayed on the screen.
6 Arrow keys ( M/m/</,)
Used to select the menu or to make various
adjustments.
7 VOLUME +/– keys
Adjust the volume of the built-in speakers and output
level of the AUDIO OUT jack.
+ : Increases the volume.
– : Decreases the volume.
8 APA (Auto Pixel Alignment) key
Adjusts a picture to be projected clearest
automatically while a signal from the computer is
input.
9 Indicators
LAMP/COVER: Lights up or flashes under the
following conditions:
• Lights up when the lamp has reached the end of
its life or becomes a high temperature.
• Flashes when the lamp cover or air filter cover
is not secured firmly.
TEMP (Temperature)/FAN: Lights up or flashes
under the following conditions:
• Lights up when temperature inside the projector
becomes unusually high.
• Flashes when the fan is broken.
POWER SAVING: Lights up when the projector is
in the power saving mode. When POWER
SAVING in the SET SETTING menu is set to
ON, the projector goes into the power saving
mode if no signal is input for 10 minutes.
Although the lamp goes out, the cooling fan
keeps running. In the power saving mode, any
key does not function for the first 30 seconds.
The power saving mode is canceled when a signal
is input or any key is pressed.
ON/STANDBY: Lights up or flashes under the
following conditions:
• Lights in red when the AC power cord is
plugged into the wall outlet. Once in the
standby mode, you can turn on the projector
with the
I / 1 key on the Remote Commander or on the
control panel.
• Lights in green when the power is turned on.
• Flashes in green while the cooling fan runs after
turning off the power with the I / 1 key. The
fan runs for about 90 seconds after turning off
the power.
The ON/STANDBY indicator flashes quickly
for the first 30 seconds.
During this time, you cannot turn the power
back on with the
I / 1 key.
For details on the LAMP/COVER and the TEMP/FAN
indicators, see page 27 (GB).
APA VOLUME
INPUT
MENU
ENTER RESET
ON
/STANDBY
POWER
SAVING TEMP
/FAN
LAMP
/COVER
9
1
2
3
4
8
7
6
5