Installing the projector, Connecting, Connecting with a computer – Sony VPL-PX1 User Manual

Page 14

Advertising
background image

14

(GB)

Installing the Projector

This section describes the installation arrangements
for installing the projector.

Horizontal center
of the screen

The distance between the lens and the screen varies
depending on the size of the screen. Use the following table
as a guide.

Unit: m (feet)

Screen

size

40

60

80

100

120

150

200

(inches)

Minimum

1.6

2.4

3.3

4.1

5.0

6.2

8.3

Distance

(5.2)

(8.0) (10.8) (13.5) (16.3) (20.4) (27.4)

Maximum

2.0

3.1

4.2

5.2

6.3

7.9

10.5

Distance

(6.7) (10.2) (13.7) (17.1) (20.6) (25.8) (34.5)

Note

You can not install the projector upside down, such
as on a ceiling.

Connecting

Connecting with a Computer

This section describes how to connect the projector
with a computer.
For details on how to connect a VCR, 15k RGB, or
component equipment, see page 16 (GB).

When the projector is connected to a computer, you
can control the mouse of a computer by the Remote
Commander.
The R/L CLICK keys and joy stick function as
follows.

Note

Make sure that there is nothing to obstruct the infrared
beam between the Remote Commander and the
remoter control detector on the projector.

Function

Key and

IBM PC/AT

a)

Macintosh

joy stick

compatible, Serial

R CLICK
(front)

Right button

Mouse button

L CLICK
(rear)

Left button

Mouse button

Joy stick

Corresponds with the movements of the mouse

a) IBM PC/AT is a registered trademark of International

Business Machines Corporation, U.S.A.

Also refer to the instruction manual of equipment to
be connected.

Notes

• This unit accepts the VGA, SVGA, XGA, and

SXGA signals. However, we recommend you to set
the output mode of your computer to the XGA mode
for the external monitor.

• If you set your computer, such as a notebook type

IBM PC/AT compatible, to output the signal to both
the display of your computer and the external
monitor, the picture of the external monitor may not
appear properly. In such cases, set the output mode
of your computer to output the signal to only the
external monitor.

For details, refer to the operating instructions supplied
with your computer.

Distance between the screen
and the center of the lens

Installing the Projector / Connecting

,,,,,

,,,,,

,,,,,

Advertising