Sony VPL-PX1 - Manual (Page 9)

9
(GB)
qd Security lock
Connects to an optional security cable (Kensington’s).
The security lock corresponds to Kensington’s
MicroSaver Security System.
If you have any comment, contact
Kensington
2853 Campus Drive, San Mates, CA 94403
U.S.A.
Tel: 800-535-4242: extension 3348
Home page address:
http://www.kensington.com/
qf 75
Ω
termination switch (bottom)
Normally set to ON. Set it to OFF when the projector
is connected to a computer or a monitor.
qg Connector panel
For details, see page 11 (GB).
qh Lamp cover (bottom)
qj Adjuster button
qk Right speaker
ql Ventilation holes (intake)/air filter cover
Notes
• Do not place anything near the ventilation holes as it
may cause internal heat build-up.
• Do not place your hand or objects near the
ventilation holes — the air coming out is hot.
w; Air filter cover button
Used to remove the air filter cover.
For details, see “Cleaning the Air Filter” on page 25 (GB).
Adjuster button
How to use the adjuster
To adjust the height
Adjust the height of the projector as follows:
1
Lift the projector and press the adjuster button.
The adjuster will extend from the projector.
2
While pressing the button, lower the projector.
Then, release the button.
Note
The adjuster has 5 settings. After releasing the
adjuster button, the height will be locked at next level.
Location and Function of Controls