Sony VPL-PX1 - Manual (Page 17)

17
(GB)
1
After all equipment is connected completely, plug
the AC power cord into the wall outlet.
The ON/STANDBY indicator lights in red and the
projector goes into the standby mode.
2
Press the I / 1 key on the Remote Commander or
on the control panel.
The ON/STANDBY indicator lights in green.
3
Turn on equipment connected to the projector.
Press the INPUT key on the Remote Commander
or on the control panel to select the input source.
Projecting
Rear remote
control detector
ON/STANDBY
indicator
APA key
APA key
INPUT-A: Selects audio and video signals input
from the INPUT A connector.
VIDEO: Selects audio and video signals input
from the video/audio input connector.
(If you connect to both the S VIDEO
and VIDEO jacks, the signal from the
S VIDEO jack is selected.)
4
Turn the zoom ring to adjust the size of the
picture.
5
Turn the focus ring to adjust the focus.
Note
Looking into the lens when projecting may cause
injury to your eyes.
To Press
Adjust the volume the VOLUME +/– keys on the control panel or
on the Remoter Commander.
Cut off the sound the AUDIO MUTING key on the Remote
Commander. To restore the sound, press the
AUDIO MUTING key again or press the
VOLUME + key.
Cut off the picture the PICTURE MUTING key on the Remote
Commander. To restore the picture, press the
PICTURE MUTING key again.
To get the clearest picture
You can get the suitable picture when a signal from
the computer is input. Press the APA key on the
Remote Commander or on the control panel.
The picture is automatically adjusted to be projected
clearest.
Notes
• Adjust the signal when the still picture is displayed
on the screen.
• If you switch the input signal or re-connect a
computer, press the APA key again to get the
suitable picture.
• “ADJUSTING” appears on the screen. Press the
APA key again during the adjustment to restore the
original screen.
• “Complete!” appears on the screen when the picture
is adjusted properly. The picture may not be adjusted
properly depending on the kinds of input signals.
• Adjust DOT PHASE in the INPUT SETTING menu
when you adjust the picture manually.
For details on DOT PHASE, see page 21 (GB).
Projecting
COMMAND
MUTING
I / 1
INPUT
APA
MENU LASER
ENTER
RESET
VOLUME
R CLICK
PICTURE AUDIO
ON OFF
APA VOLUME
INPUT
MENU
ENTER RESET
ON
/STANDBY
POWER
SAVING TEMP
/FAN
LAMP
/COVER
5
4
1
2
3
2
3