Sony NSA-PF1 - Manual (Page 15)

NSA-PF1(GB/ES) 4-124-178-11 (2)
1
conserve natural resources. In case of products that for safety,
performance or data integrity reasons require a permanent
connection with an incorporated battery, this battery should be
replaced by qualified service staff only. To ensure that the battery
will be treated properly, hand over the product at end-of-life to the
applicable collection point for the recycling of electrical and
electronic equipment. For all other batteries, please view the
section on how to remove the battery from the product safely.
Hand the battery over to the applicable collection point for the
recycling of waste batteries. For more detailed information about
recycling of this product or battery, please contact your local Civic
Office, your household waste disposal service or the shop where
you purchased the product.
For the customers in the UK, Ireland, Malta, and
Cyprus
Use the AC power cord set ( ).
For safety reasons, the AC power cord set ( ) is not intended for
above mentioned countries/regions and shall therefore not be
used there.
For the customers in the following regions
For all other countries part of the European Economic Area use
the AC power cord set (
).
Warning
Both power cord sets are not intended to be used in Switzerland
and Liechtenstein.
About the AC power cord (mains lead)
The supplied AC power cord (mains lead) is only for use with this
unit (NSA-PF1). Do not use with other components.
About the location of the nameplate
The nameplate is located on the
aluminium pipe (when the sleeve is
attached, the nameplate is hidden).
Inserting batteries into the remote
Insert two R0 (size AAA)
batteries by matching the
 and
 ends on the batteries to the
markings inside the compartment.
 Do not leave the remote in an
extremely hot or humid place.
 Do not drop any foreign object
into the remote casing, particularly when replacing the batteries.
 Wrong usage of the batteries may cause battery leakage or
battery rupture. To prevent this, observe the following.
- Do not use a new battery with an old one. Do not use different
types of batteries.
- Do not attempt to charge the batteries.
- If you do not intend to use the remote for an extended period
of time, remove the batteries.
- If battery leakage occurs, avoid touching the liquid. Wipe the
liquid thoroughly before inserting new batteries.
 Do not expose the remote sensor to direct sunlight or lighting
apparatus. Remote control operation may be affected.
Use a coin, etc. to unlock.
Nameplate
 