Sony RHT-S10 - Manual (Page 28)

28 US
1
Make sure that the unit is connected to
the TV and the connected components
(which should be compatible with the
Control for HDMI function) using HDMI
cables (not supplied).
2
Turn on the unit, the TV and the
connected components.
3
Select the input of the unit connected to
the component you want to watch (BD/
DVD, SAT), and switch the HDMI input
of the TV, so that an image from the
connected component is displayed.
4
Set the Control for HDMI function of the
TV to on.
The Control for HDMI function for the unit
and the connected component is
simultaneously set to on.
During the setting, “SCANNING” appears
in the front panel display. After you finish
the setting, “COMPLETE” appears in the
front panel display. Wait until the setting is
complete.
If “SCANNING” or “COMPLETE”
does not appear after performing
the steps above
Set the Control for HDMI function to on for the
unit and the connected component individually.
1
Press AMP MENU.
2
Press x/X repeatedly until
“CUSTOMIZE” appears, then press
or c.
3
Press x/X repeatedly until “CTRL:
HDMI” appears, then press or c.
4
Press x/X to select “CTRL ON.”
5
Press AMP MENU.
The AMP menu turns off. The Control for
HDMI function is set to on.
6
Set the Control for HDMI function of the
connected component to on.
For details on setting the connected
component, refer to its operating
instructions.
7
Select the input of the unit connected to
the component you want to use the
Control for HDMI function for (BD/DVD,
SAT), and repeat step 6.
If you add or reconnect the
component
Perform steps of “Preparing for the “BRAVIA”
Sync” and “If “SCANNING” or “COMPLETE”
does not appear after performing the steps
above” again.
• During the setting of the Control for HDMI function
for the unit, the System Audio Control function does
not work.
• If the Control for HDMI function for the connected
component cannot be set simultaneously by setting
“CONTROL FOR HDMI” of the TV, set the Control
for HDMI function using the menu of the connected
component.
• For details on setting the TV and the connected
components, refer to their operating instructions.
• The default setting of the Control for HDMI function
of the unit is “CTRL OFF.”
Notes
Tip