Sony RMT-840 - Manual (Page 47)

Pla
yba
ck
Playback 47
format is played back, an equivalent signal
with [480i] is output, even if [1080i/480i] is
selected.
• Only video signals are output from the
COMPONENT OUTPUT jack. To output
audio signals, connect the white and red plugs
of the A/V connecting cable to the audio input
jack of your TV.
To connect the TV using the A/V
connecting cable
When there is an S video jack on the device to
be connected, connect it with your camcorder
by the S video jacks using an S video cable
(optional) instead of the yellow video plug of
the A/V connecting cable (supplied). This
connection produces pictures more faithfully on
the TV connected. The audio will not be output
when you connect with the S video cable alone.
b Note
• Be sure that you set [VCR HDV/DV] before
connecting the i.LINK cable. Otherwise, the TV
might not be able to recognize the video signal
correctly.
• Pictures in the DV format are not output from the
COMPONENT OUT jack, if copyright protection
signals are recorded in the pictures.
z Tip
• If you connect your camcorder to your TV using
more than one type of cables to output the pictures in
analog signal, the output signals have priority in the
following order:
COMPONENT OUTPUT jack
t S video jack t
AUDIO/VIDEO jack
• See page 94 for details on i.LINK.
When your TV is connected to a VCR
Connect your camcorder to the LINE IN input
on the VCR using the A/V connecting cable. Set
the input selector on the VCR to LINE.