Sony XAV-701HD - Manual (Page 38)

38
Pairing
Pairing is required only the first time you connect
to a Bluetooth device (cellular phone, etc.).*
For details, refer to the manual of the Bluetooth
device.
* If you delete the device registration from this unit,
you need to perform pairing again.
Tip
You can pair up to 9 devices.
Searching from the Bluetooth
device
The procedure to search for this unit from the
other Bluetooth device is explained below.
1
Press (HOME), then touch “Settings.”
2
Touch , and move the scrollbar up
and down.
3
Touch “Bluetooth Connection,” then
set the signal to “ON.”
The Bluetooth signal of this unit is activated.
4
Touch “Pairing >.”
This unit is ready to be detected by the other
Bluetooth device.
5
Operate the Bluetooth device to
search for this unit.
A device list appears on the display of the
device. This unit is displayed as “Sony
Automotive.”
6
If passkey* input is required on the
display of the device, input “0000.”
This unit and the Bluetooth device memorize
each other’s information, and when pairing is
made, this unit is ready for connection to the
device.
7
Operate the Bluetooth device to
connect to this unit.
Bluetooth device name appears and
connection is complete. “
” or “ ” appears
when the connection is made.
* Passkey may be called “passcode,” “PIN code,” “PIN
number,” “password,” etc., depending on the
Bluetooth device.
Notes
• While connecting to a Bluetooth device, this unit
cannot be detected from another device. To enable
detection, disconnect the current connection.
• It may take time to search or connect.
• Depending on the device, the connection
confirmation display may appear before inputting the
passkey.
• The time limit for inputting the passkey differs
depending on the device.
• This unit cannot be connected to a device that
supports only HSP (Head Set Profile).
Connecting
When the ignition is turned to on with the
Bluetooth signal activated, this unit searches for
the last-connected Bluetooth device, and
connection is made automatically if possible.
This chapter explains how to connect manually
to registered Bluetooth devices.
Before starting, be sure to activate the Bluetooth
signal both on this unit (page 43) and the other
Bluetooth device.
To connect from the other Bluetooth
device
Operate the other Bluetooth device to connect to
this unit.
When connection is made successfully,
or
appears at the top of the display.
Note
If connection is made during audio streaming, noise
may occur over playback sound.
Tip
You can connect a cellular phone for audio streaming
if it supports A2DP (Advanced Audio Distribution
Profile).
XXXXXXX
DR-BT30Q
Sony
Automotive
XXXX
Input passkey.
“0000”