Sony DCR-TRV25 - Manual (Page 52)

52
(1) When fading in [a]
In the standby mode, press FADER until the desired fader indicator flashes.
When fading out [b]
In the recording mode, press FADER until the desired fader indicator flashes.
The indicator changes as follows:
FADER t M. FADER t BOUNCE t MONOTONE t OVERLAP
no indicator
DOT WIPE
The last selected fader mode is indicated first of all.
(2) Press START/STOP. The fader indicator stops flashing, then light up.
After fade in/out ends, your camcorder automatically returns to the normal
mode.
To cancel the fader function
Before pressing START/STOP, press FADER until the indicator disappears.
Note
You cannot use the following functions while using the fader function. Also, you cannot
use the fader function while using the following functions:
– Digital effect
– Super NightShot
– Color Slow Shutter
– Recording still images on a “Memory Stick” in the tape recording or standby mode
(except DCR-TRV16)
– Tape Photo recording
– Interval recording
– Frame recording
When you set the POWER switch to MEMORY (except DCR-TRV16)
You cannot use the fader function.
When the OVERLAP, WIPE, or DOT indicator appear in the standby mode
Your camcorder automatically stores the image recorded on a tape. While the image is
being stored, the indicators flash fast, and the playback picture disappears. At this
stage, the picture may not be recorded clearly, depending on the tape condition.
Using the fader function
1
FADER
FADER
START/STOP