Sony DCM-M1 User Manual
Page 101
101
Using with Other Equipment
Viewing on the computer display
Step 1 Setting the address for your camcorder
Set the camcorder’s address so that you can access your camcorder from the computer.
You do not need to reset the address as long as the computer is used under same
environment.
(1) Touch
ADVANCED, then PC CONNECT.
(2) Touch SET UP.
The screen to set IP address, etc. appears.
(3) Touch MANUAL to put a black dot in the white circle.
You can set the IP address, net mask, and gateway.
(4) Set the IP address.
You can keep as it is, or put any desired number. This number becomes your
camcorder’s homepage address.
Net mask: For example, set to 255.255.255.0.
Gateway: If you are not sure, set to 0.0.0.0.
(5) Touch EXEC.
If you change the setting, touch CANCEL and repeat from step 1.
(6) Touch CONFIRM.
The camcorder automatically turns off and on again. The setting is completed.
To set the IP address on the computer
Set the IP address on the computer in accordance with your camcorder.
In case of the above setting (192.168.0.10), set as follows:
IP address: 192.168.0.X (X can be any number from 1 to 254 except 10. Do not use the
same number for the last digit as that of the camcorder’s IP address.)
Net mask: 255.255.255.0
Gateway: Keep blank.
To operate the menu
You can use the control dial.
To return to the previous screen
Touch RETURN.
The first digit of IP address
Changes ranging from 0 to 223.
ADVANCED
RETURN
PC CONNECT
SET UP RESET
DISC FORMAT
CONNECT
SET UP
SET UP RESET
IP address
Automatic (DHCP)
Manual
EXEC
CANCEL
Net mask
Gateway
192 168
0
10
255 255 255
0
0
0
0
0
SET UP RESET
IP address
Automatic (DHCP)
Manual
EXEC
CANCEL
Net mask
Gateway
168
0
10
255 255 255
0
0
0
0
0
192