Sony KLV-23HR1 - Manual (Page 14)

14
Installing and Connecting the TV
VHF/UHF R-AUDIO-L VIDEO S VIDEO
VIDEO 1 IN AUDIO OUT
R L DC IN 14.5V R-AUDIO-L
VIDEO 3 IN
Y P B P R
VIDEO (yellow)
AUDIO-R (red)
VMC-810S/820S
(not supplied)
VCR
S VIDEO
Rear of TV
Satellite receiver
75-ohm
coaxial
cable
(supplied)
Cable YC-15V/30V
(not supplied)
VMC-
810S/820S
(not supplied)
Connecting a Satellite Receiver with a VCR
Disconnect all power sources before making any connections.
1
Connect the satellite antenna cable to the satellite receiver’s SATELLITE
IN jack.
2
Connect the CATV cable to the VCR’s VHF/UHF IN jack.
3
Using the supplied 75-ohm coaxial cable, connect the VCR’s OUT jack
to the TV’s VHF/UHF jack.
4
Using AUDIO and S VIDEO cables, connect the satellite receiver’s
AUDIO and S VIDEO OUT jacks to the VCR’s AUDIO and S VIDEO
IN jacks.
5
Using AUDIO and S VIDEO cables, connect the VCR’s AUDIO and S
VIDEO OUT jacks to the TV’s AUDIO and S VIDEO IN jacks.
Note
To watch the pictures input from the S VIDEO input jack, set “Auto YC” to “On” in the
(Setup) menu (See page 12).
Tips
• You can also use the VIDEO 2 IN jacks on the front panel of the TV to connect your VCR.
• Be sure your VCR’s video input is set correctly. Consult your VCR’s operating manual for
instructions.
• Use TV/VIDEO on the remote control to select VIDEO 1 IN (or VIDEO 2 IN if you use the
VIDEO 2 IN jacks for this hookup) to watch satellite TV or to watch a tape on the VCR
(your VCR must be turned on).
• If your VCR or satellite receiver is not equipped with S VIDEO, use a VIDEO cable
(yellow) instead of the S VIDEO cable.
75-ohm coaxial cable (supplied)
YC-15V/30V
(not supplied)
AUDIO-L (white)
Satellite
antenna
cable