Sony KLV-23HR1 - Manual (Page 9)

9
Installing and Connecting the TV
75-ohm coaxial
cable (supplied)
Rear of TV
VHF/UHF
Basic Connections
(Connecting Cable TV or
an Antenna)
When connecting an antenna or cables, remove the
rear cover of the TV beforehand.
Removing the rear cover
1
Slide the rear cover upward by approx. 1 cm
(
13 /
32
inch) while holding it with both hands as
shown in the diagram below.
2
Pull the rear cover towards you.
Rear of TV
VHF/UHF
IN OUT
Cable
Cable box
75-ohm coaxial
cable (supplied)
Connecting directly to cable or an
antenna
VHF only or VHF/UHF or cable
Note
It is strongly recommended to connect the antenna using a 75-
ohm coaxial cable to get optimum picture quality. A 300-ohm
twin lead cable can be easily affected by radio noise and the like,
resulting in signal deterioration. If you use a 300-ohm twin lead
cable, keep it away as far as possible from the TV.
Cable box connections
Use this hookup if:
• You subscribe to a cable TV system that uses
scrambled or encoded signals requiring a cable
box to view all channels, and
• You do not intend to hook up any other audio or
video equipment to your TV.
1
Connect the coaxial connector from your cable
service to the cable box’s IN jack.
2
Using the supplied 75-ohm coaxial cable,
connect the cable box’s OUT jack to the TV’s
VHF/UHF jack.
Also, set “Cable” to “On” in the (Channel)
menu (See page 20).
Tips
• Your Sony remote control can be programmed to operate your
cable box (See “Programming the remote control” on page
31).
• To change channels using the cable box, set your TV to
channel 3 or 4 depending on the cable box channel output.
• If you will be controlling all channel selection through your
cable box, consider using the Channel Fix feature to set your
TV to channel 3 or 4 (See page 21).
A
A
Attaching the rear cover
1
Hold the rear cover with both hands, then fit the
four detents on the rear cover into the
corresponding keyholes on the TV while keeping
the rear cover approx. 1 cm (
13 /
32
inch) higher
than the TV as shown in the diagram below.
2
Slide the rear cover downward while keeping it
pressed against the TV. If the rear cover fails to
fit in the lower keyholes, push it simultaneously
at the positions marked A in the illustration
below.