Agilent Technologies Agilent 4396B - Manual (Page 38)

Figure 1-9. Connecting a K eyboard
Setting Up a 75 Measurement F or Spectrum Analyzer Mode
Note This operation requires the option 1D7 50
to 75
Input Impedance
Conversion. F or detail information about option 1D7, see chapter 9 of
the Function R eference manual.
1. Attach the 11852B Option C04 50
N(m)/75 N(f) minimum loss
pad to the S input. This minimum loss pad is furnished with the
option 1D7.
2. Press 4 Cal 5 .
3.
Press
NNNNNNNNNNNNNNNNNNNNNNN
INPUT Z .
4. Press 4 * 5 to set the impedance of the source (75
). Then press
4 Entry O 5 .
Note P erform this procedure each time the analyzer is preset because the
analyzer does not retain this setting in memory .
1-18 Installation and Setup Guide