Sony NEX-VG900 - Manual (Page 101)

101
Table of C
on
ten
ts
Sear
ch image
Inde
x
US
If you cannot use memory cards that have been
used with another device, format it with your
camcorder (p. 81). Note that formatting erases
all information on the memory card.
You may not be able to play back images with
your camcorder:
When playing back image data modified on
your computer
When playing back image data recorded with
other devices
About the “Memory Stick” media
Types of “Memory Stick” media Recording/Playback
“Memory Stick Duo” media
(with MagicGate)
—
“Memory Stick PRO Duo”
media (Mark2)

“Memory Stick PRO-HG
Duo” media

“Memory Stick XC-HG Duo”
media

This product supports parallel data transfer.
However, the transfer speed may differ,
depending on the type of media you use.
This product cannot record or play data that
uses “MagicGate” technology. “MagicGate” is
a copyright protection technology that records
and transfers the contents in an encrypted
format.
About the “InfoLITHIUM” battery
pack
Your camcorder operates only with an
“InfoLITHIUM” V series battery packs.
“InfoLITHIUM” V series battery packs
have the mark.
To charge the battery pack
Be sure to charge the battery pack before you
start using your camcorder.
We recommend charging the battery pack in an
ambient temperature of between 10  C to 30  C
(50 °F to 86 °F) until the CHG (charge) lamp
turns off. If you charge the battery pack outside
of this temperature range, you may not be able
to charge it efficiently.








To use the battery pack effectively
Battery pack performance decreases when the
ambient temperature is 10  C (50 °F) or below,
and the length of time you can use the battery
pack becomes shorter. In that case, do one
of the following to use the battery pack for a
longer time.
Put the battery pack in a pocket to warm it
up, and install it on your camcorder right
before you start taking shots.
Use a large capacity battery pack: NP-FV100
(sold separately).
Be sure to close the LCD screen when not
recording or playing back on your camcorder.
The battery pack is also consumed when your
camcorder is in recording standby or playback
pause.
Have spare battery packs ready for 2 or 3 times
the expected recording time, and make trial
recordings before making the actual recording.
Do not expose the battery pack to water. The
battery pack is not water resistant.
About the remaining battery time
indicator
When the power goes off even though the
remaining battery time indicator indicates that
the battery pack has enough power to operate,
charge the battery pack fully again. Remaining
battery time will be indicated correctly. Note,
however, that the battery indication will not be
restored if it is used in high temperatures for
a long time, or if left in a fully charged state,
or when the battery pack is frequently used.
Use the remaining battery time indication as a
rough guide only.
The  mark that indicates low battery may
flash, even if there is still 20 percent of battery
charge remaining, depending on the operating
conditions or ambient temperature.
About storage of the battery pack
If the battery pack is not used for a long time,
fully charge the battery pack and use it up on
your camcorder once a year to maintain proper
function. To store the battery pack, remove it
from your camcorder and put it in a dry, cool
place.
To discharge the battery pack on your
camcorder completely, touch (MENU)
 [Setup]  [ ( General Settings)]
 [A. Shut Off]  [Off], and leave your
camcorder in recording standby until the power
goes off (p. 85).









