Sony NEX-VG900 - Manual (Page 20)

0
Table of C
on
ten
ts
Sear
ch image
Inde
x
US
To remove the mount adaptor
Hold down the lens release button on the camcorder body and turn the mount adaptor
counterclockwise until it stops. Carefully lift the mount adaptor out of the camcorder’s mount.
If dust or debris adheres on the image sensor
Turn off the camcorder and detach the lens. Clean the image sensor and the surrounding area
using a blower (sold separately), and then reattach the lens.
Notes
Do not use a spray blower because it may scatter water droplets inside the camcorder body.
Do not put the tip of a blower into the cavity beyond the mount, so that the tip of the blower does not
touch the image sensor.
Hold the camcorder’s face downward to prevent the dust from resettling in the camcorder.
Do not apply a mechanical shock to the camcorder during cleaning.
If you cannot clean the image sensor by the above procedure, consult your Sony dealer or local authorized
Sony service facility.






Lens release button