Sony NEX-VG900 - Manual (Page 92)


Table of C
on
ten
ts
Sear
ch image
Inde
x
US
A photo cannot be captured from a movie
(NEX-VG900).
The memory card where you want to save
photos is full.
Playback on the TV
Neither image nor sound is played on the
connected TV.
When you are using the component A/V
cable, set [Component] according to the
requirements of the connected device (p. 83).
When you are using the component video
plug, make sure the red and white plugs of the
A/V connecting cable are connected (p. 36).
Images are not output from the HDMI OUT
jack, if copyright protection signals are
recorded in the images.
When you are using the S VIDEO plug,
make sure the red and white plugs of the A/V
connecting cable are connected (p. 37).
When [24p Mode] is activated, recorded
images may not be played back even though
the camcorder is connected to a PAL-based
TV (NEX-VG900E).
The top, bottom, right, and left edges
of images are trimmed slightly on a
connected TV.
The LCD screen of your camcorder can
display recording images across the entire
screen (full pixel display). However, this may
cause slight trimming of the top, bottom, right,
and left edges of images when played back on
a TV which is not compatible with full pixel
display.
It is recommended you record images using
the outer frame of [Guide Frame] (p. 75) as
a guide.
The image appears distorted on the 4:3
TV.
This happens when viewing an image
recorded in the 16:9 (wide) mode on a 4:3 TV.
Set [TV Type] correctly (p. 82) and play back
the image.









Black bands appear at the top and bottom
of the screen of the 4:3 TV.
This happens when viewing an image recorded
in the 16:9 (wide) mode on a 4:3 TV. This is
not a malfunction.
Copying/Connecting to other
devices
Images are not copied correctly.
You cannot copy images using the HDMI
cable (sold separately).
The A/V connecting cable is not connected
properly. Make sure to connect the cable to the
input jack of another device (p. 63).
Connecting to a computer
“PlayMemories Home” cannot be installed.
Check the computer environment or
installation procedure required to install
“PlayMemories Home.”
“PlayMemories Home” does not work
correctly.
Quit “PlayMemories Home” and restart your
computer.
The camcorder is not recognized by the
computer.
Disconnect devices from the USB jack of the
computer other than the keyboard, mouse,
and your camcorder.
Disconnect the USB cable (supplied) from the
computer and your camcorder, and restart
the computer, then connect the computer and
your camcorder again in the correct order.






