Sony PEG-NZ90 - Manual (Page 24)

24
If you still cannot perform a HotSync
®
operation
If you cannot solve your HotSync operation problem by following the
troubleshooting items, follow the procedure below.
Check if any “Unknown device” is listed in the Device
Manager on your computer.
1
Right-click My Computer and select Properties from the
menu.
The System Properties screen is displayed.
2
If you are using Windows 2000 Professional/Windows XP,
click the Hardware tab.
3
Click the Device Manager tab.
4
Check if there is a device marked with or .
A device with such mark is not operating normally. Contact the
manufacturer of the device to get information on the latest device drivers.
You cannot perform a HotSync
®
operation before you
install the Palm™ Desktop for CLIÉ software on your
computer
If you perform a HotSync
®
operation before you install the CLIÉ drivers, other
drivers may be installed and a problem may occur in your computer system.
Make sure you install the Palm ™ Desktop for CLIÉ software before
performing a HotSync
®
operation.
Do not use a USB hub
If you connect the cradle to your computer via a USB hub, you may not be able
to perform a HotSync
®
operation properly. Make sure you connect the cradle
directly to a USB port of your computer.
Some computers have the hub function built into their internal circuitry.
Contact your computer manufacturer to check whether the USB connector of
your computer is connected to an internal USB hub.