Sony KLH-40X1 - Manual (Page 55)

21 GB
GB
Tip
You can alter the “Picture” settings (“Picture”, “Brightness”, “Color”, etc.) for each “Picture Mode”.
• In the “ PAP ” mode, none of the options of the “Picture” settings can be selected.
• If there is no signal currently being input, none of the options of the “Picture” setting can be selected.
For PC Input
• “Color”, “Hue”, “Sharpness”, “Noise Reduction” and “CineMotion” are not available for PC input.
• In the “PAP” mode, none of the “Picture” settings options can be selected.
• If there is no signal currently being input, none of the options of the “Picture” setting can be selected.
True Color Control You can adjust the details of hue and saturation for each of 4 colors : red, green,
yellow, blue, and you can highlight specific colors in the image.
Select the color which you want to adjust, and you can check and see which part of
current image will be adjusted. Then you can adjust it using the matrix dialog.
• This option can be adjusted when “Picture Mode” is set to “TC Control”.
• In “PAP” mode, you cannot select this option. Even if you select this option in the single-
picture screen, the setting of this option may not be applied in the “PAP” mode.
Notes
When input is switched to a PC input source, the
“Picture” settings specific to PC input are applied.
The PC “Picture” settings include the following
options:
Picture Mode “Vivid”: Select for enhanced picture contrast and sharpness.
“Standard”: Select for standard picture settings.
“Custom”: Allows you to store preferred settings.
“TC Control”: The setting is common with “Vivid”. In addition, you can use the
“True Color Control” function (after-mentioned).
Picture Mode Reset Resets all settings and adjustments currently selected in “Picture Mode” (“Vivid”,
“Standard”, “Custom”, “TC Control”) to the default setting (except for the options
grayed out).
Picture Adjust to increase or decrease picture contrast.
Brightness Adjust to brighten or darken the picture.
Color Temp. “Cool”: Select to give the white colors a blue tint.
“Neutral”: Select to give the white colors a neutral tint.
“Warm”: Select to give the white colors a red tint.
True Color Control See “True Color Control” for video input (page 21).
Notes
: : :
Notes