Axis Communications AXIS 214 PTZ - Manual (Page 46)

46 AXIS 214 PTZ - System Options
Network - SMTP (email)
(Simple Mail Transfer Protocol) Enter the host names or addresses for your primary and
secondary mail servers in the fields provided to enable event and error email messages
from the AXIS 214 PTZ to predefined addresses, via SMTP.
Network - SNMP
The Simple Network Management Protocol (SNMP) allows the remote management of
network devices. The AXIS 214 PTZ can be configured to support SNMP. See the online
help.
Network - UPnP™
The AXIS 214 PTZ includes support for UPnP™ in Windows Millennium and Windows XP.
Enabled by default.
Note:
UPnP™ must be installed on your workstation. To do this, open the Control Panel from the Start Menu and
select Add/Remove Programs. Select Add/Remove Windows Components and open the Networking Ser-
vices section. Click Details and then select UPnP as the service to add.
Network - RTP
These settings are for the IP addresses, port numbers, and Time-To-Live values to use for
media streams in the MPEG-4 format. Only certain IP addresses and port numbers should
be used for these streams. For more information, please see the online help.
Ports & Devices - I/O Ports
The pinout, interface support and the control and monitoring functions are described in
the section on the Connections, on page 49.
Maintenance
• Restart - The unit is restarted without changing any of the settings. Use this method if
the unit is not behaving as expected.
• Restore - The unit is restarted and most current settings are reset to factory default val-
ues. The settings that will not be reset are as follows:
• the boot protocol (DHCP or static)
• the static IP address
• the default router
• the subnet mask
• the system time
Default - The Factory default button should be used with caution. Pressing this button will
reset all of the AXIS 214 PTZ's settings to the factory default values (including the IP
address).