Axis Communications AXIS 214 PTZ - Manual (Page 48)

48 AXIS 214 PTZ - System Options
For more information, please visit the Developer pages at www.axis.com/developer
Plain Config - this function is for the advanced user with experience of Axis network
camera configuration. All parameters can be set and modified from this page. Help is
available from the standard help pages.
Resetting to the factory default settings
To reset the AXIS 214 PTZ to the original default settings, go to the System Options >
Maintenance web page (described in Maintenance, on page 46) or use the Control button
on the rear panel of the AXIS 214 PTZ, as described below:
Using the Control Button
Follow the instructions below to reset the AXIS 214 PTZ to the factory default settings
using the Control Button.
1. Switch off the AXIS 214 PTZ by disconnecting the external power supply.
2. Using a suitably pointed object, press and hold the Control button while
reconnecting the power connector.
3. Keep the Control button pressed for approximately 15 seconds.
4. Release the Control button.
Note:
Resetting to the factory default settings using the Control Button will cause all parameters (including the
IP address) to be reset. Refer to Maintenance, on page 46 for other methods that do not reset the IP
address.