Panasonic BL-C1A - Manual (Page 34)

Operating Instructions
34
Host Name
(DHCP Only) • If your ISP uses the DHCP function, which automatically
assigns an IP address to the camera, enter the ISP-
assigned host name. (The host name may be used as an
authentication.)
• Enter ASCII characters for the host name (see page 131).
Note that [Space], ["], ['], [&], [<] and [>] are not available.
Default Gateway *1
(Static/DHCP Only)
• If you have been assigned a Default Gateway address by
your ISP or network administrator, enter it in this data field.
• Set 4 numbers (0—255) and 3 periods, such as
"192.168.0.253". Note that "0.0.0.0" and
"255.255.255.255" are not available.
DNS Server
Address
*1
(Static/DHCP Only)
• The DNS server address is required in the following
situations:
–
Transferring camera images by E-mail or FTP
– Setting cameras by their host names on the Multi-
Camera Setup page
– Using the DynamicDNS service
– Using the sensor log notification
• If you have been assigned a DNS server addresses by
your ISP or network administrator, enter them in this data
field. There are usually two addresses.
• Set 4 numbers (0—255) and 3 periods, such as
"192.168.0.253". Note that "0.0.0.0" and
"255.255.255.255" are not available.
Max. Bandwidth
Usage • The bandwidth can be restricted.
• Select a maximum bandwidth from [Unlimited] to [0.1
Mbps].
Note
Set a maximum bandwidth referring to the following file
sizes. These are examples for a JPEG file of standard
image quality. File sizes may change depending on the
image quality or the brightness of the object.
160 × 120 pixels: About 3 KB (24 Kbit)
320 × 240 pixels: About 10 KB (80 Kbit)
640 × 480 pixels: About 18 KB (144 Kbit)
Setting Description