Using lp mode, Using the aux input, Auto power off – Panasonic SC-NA30 User Manual

Page 13: Using lp mode using the aux input auto power off

Advertising
background image

VQ

T5

C3

6

13

This mode minimizes power consumption of the battery by lowering the speaker
output. (> 8)
Press and hold [LP] for 2 seconds or more until the LP mode indicator
(green) lights up.

The LP mode is enabled.

• Press and hold [LP] for 2 seconds or more again will return the setting back to the normal mode.

Note

• Even when the AC adaptor is connected, LP mode remains enabled.
• In LP mode, even when the volume knob is adjusted, the volume of the unit may not increase.
• Turning off the LP mode may cause the volume to jump up suddenly. Before turning off the LP

mode, lower the volume.

You can listen to audio via the AUX IN jack (> 6, 7) when this unit is connected to
a device with an audio cable (commercially-available).

Note

• When using the AUX input, AUX input has priority than the Bluetooth

®

features and NFC

features.
(It will be possible to receive a call hands-free by pressing [

] when there is a call coming

in on the device connected with Bluetooth

®

. > 14)

• The setting of the Bluetooth

®

is not changed even if the audio cable (commercially-available)

is inserted into AUX IN jack.

• When using the AUX input, the volume may seem low depending on the connected device. In

that case, check if the volume limit can be changed on the device. For details, refer to the
manual of the device.

• If an audio cable (commercially-available) is inserted during audio playback with a Bluetooth

®

connection, noise may occur. In this case, stop the playback on the device connected via Bluetooth

®

.

This unit automatically turns off if there is no audio input and no operation is
performed for approximately 10 minutes.

Note

• If the AUX IN jack is in use while the AC adaptor is connected, this function will not work.
• This function may operate even when the music is being played back if the volume of the

connected device is low.

• This function may not operate depending on the connected device.
• When the DC OUT terminal is in use, this function will not work.
[NA30]
• The Auto Power Off function is activated, the retractable panel will remain lowered when the unit

is turned off. To leave the retractable panel raised when the unit is turned off, press [Í/I] twice.

Using LP mode

Using the AUX input

Auto Power Off

SC-NA30_10PPC_VQT5C36_eng.book 13 ページ 2013年8月8日 木曜日 午前10時39分

Advertising
This manual is related to the following products: