About the dc out terminal (usb) – Panasonic SC-NA30 User Manual

Page 9

Advertising
background image

VQ

T5

C3

6

9

Note

• Do not use any other AC adaptors except the supplied one.
• When this unit is not used over a long period of time, charge the built-in battery at least once

every six months to prevent it from deteriorating.

• Charging may not start if the battery level is sufficiently high even if it is not full.
• It is recommended to charge the battery in the temperature of between 10 oC and 35 oC

(i50 oF to i95 oF). The Battery indicator (red) may flash and charging may not be possible
when it is out of recommended temperature range.

• The battery may not charge when the temperature surrounding the battery is high during the

operation or right after the operation even when it is within the recommended temperature
range. In such case, stop the usage and let it cool down.

• To ensure safety, in the case of an excessive input signal, the system may be automatically

interrupted and power is turned off.

• Use of the DC OUT terminal will reduce the operating time.

The DC OUT terminal of this unit is for supplying/charging power to a connected
device (rated value: 5 V/1 A). Note that the port cannot be used for purposes other
than supplying/charging power.
Note that when the unit is turned off, charging is not possible.
Preparation
Turn on the unit.

1

Using a USB cable
(commercially-available),
connect the unit and a
compatible device.

2

Once fully charged, remove
the USB cable
(commercially-available)
from the DC OUT terminal.

Note

• A cable compatible with your device is required. If a cable is supplied with your device, use the cable.
• Even if you connect a cable compatible with the DC OUT terminal of this unit, your device may

not be charged. In that case, use a charger supplied with your device.

• Depending on your device, charging methods other than the specified one may not be

allowed. Check the operating instructions of your device before use.

• Do not connect a device with a rated value higher than 5 V/1 A to this unit. Doing so may

cause malfunction.

• To check if charging is complete, look at the screen of the connected device, etc.
• After charging, pull out the compatible cable.

About the DC OUT terminal (USB)

[NA30]

[NA10]

To the compatible device

USB cable
(commercially-
available)

Rear view

SC-NA30_10PPC_VQT5C36_eng.book 9 ページ 2013年8月8日 木曜日 午前10時39分

Advertising
This manual is related to the following products: