Panasonic SC-NA30 - Manual (Page 15)

VQ
T5
C3
6
15
Before requesting service, make the following
checks. If you are in doubt about some of the
check points, or if the solutions indicated in
the following guide do not solve the problem,
refer to “Customer Services Directory (United
States and Puerto Rico)” (> 21) if you reside
in the U.S.A. or Puerto Rico, or refer to
“Limited Warranty (ONLY FOR CANADA)”
(> 22) if you reside in Canada.
[NA30]
The retractable panel is not operating correctly.
• The Auto Power Off function is activated,
the retractable panel will remain lowered
when the unit is turned off. To leave the
retractable panel raised when the unit is
turned off, press [Í/I] twice.
Sound from the device is cut off.
• Simultaneous use with other 2.4 GHz
devices, such as microwaves, cordless
telephones, etc., may result in connection
interruptions. Increase the distance
between this system and these devices.
• Do not place the unit in a place where radio
waves will be blocked, such as a metal cabinet.
• The device is out of the 10 m (33 ft.)
communication range. Move the device nearer
to this unit. (See “About Bluetooth
® ” > 4)
• Remove any obstacle between this
unit and the device.
• Switch off any wireless LAN device.
• Select “Emphasis on connectivity” for
stable communication. (See “Switching
the communication quality” > 12)
• When a PC and the unit are connected
with Bluetooth ® , check the sound output
destination setting of the PC. If the
sound skips or is not output correctly in
other ways, perform “To return to the
factory preset state” (> 14), and
register the unit to the Bluetooth
®
device again. (> 10, 11)
• Depending on the device connected to
the unit, sound may be cut off or noise
may be produced. When this happens,
lower the volume of the device.
• When both the AUX IN jack and DC IN
terminal are in use, noise may occur
depending on the connected device. In
this case, disconnect the AC adaptor.
The volume does not increase.
• Check the volume of the unit or the
Bluetooth ® device.
• In LP mode, even when the volume
knob is adjusted, the volume of the
unit may not increase. In this case,
turn off the LP mode. (> 13)
The device cannot be connected.
• Refer to the operating instructions of
the device, and perform the pairing
operation again. (See “Pairing with
Bluetooth
® device” > 10)
• Make sure that this unit is not
connected to a different device.
• The registration information of the unit may
have been deleted from the Bluetooth ®
device. Register the unit again.
• Delete the registration information of
the unit through the Bluetooth ® menu,
etc. on the Bluetooth ® device first, and
try to register the device again. (> 14)
The device is connected but audio
cannot be heard from this unit.
• For some built-in Bluetooth
® devices, you
have to set the audio output to “SC-NA30” or
“SC-NA10” manually. Read the operating
instructions of the device for details.
• When the AUX IN jack is in use, the
jack takes priority over the Bluetooth ®
function or the NFC function.
This unit is not operating correctly.
For example, this unit turns off all of
a sudden or all indicator blink.
• Using a paper clip or similar material,
press the [RESET]. (> 6, 7)
Troubleshooting
SC-NA30_10PPC_VQT5C36_eng.book 15 ページ ２０１３年８月８日 木曜日 午前１０時３９分