Panasonic NCZA1 - Manual (Page 23)

GB23
6
Press to start brewing.
(e.g.: When cappuccino is selected)
Time bar is increasing according to process.
Wait until display shows
to remove the cup(s).
Note
•Be careful with steam coming out after
is pressed.
•If is pressed during the brewing process, it immediately
stops the process.
After
flashes, the display will move on to step 7.
•If the temperature of the water is not sufficient to brew coffee, the
heating up process will be performed first.
•When brewing cappuccino or Latte Macchiato, the display shows as
follows.
Between brewing milk and coffee, brewing will
be paused.
•If surface of milk is higher than the spouts position, it may cause milk
to drip from the dispenser. In that case pull out the milk hose.
(simple rinsing)
7
Fill a glass with clean water and press to start rinsing.
•This cleaning cycle is for next drink preparation without milk residue.
•Switch the milk hose from milk package to the glass and set the empty cup under the dispenser. (Cup size > 250 mL)
The display will return to the main menu
when the rinsing cycle is completed.
Note
•If you prepare milk menu continuously, skip this cycle by pressing
.
•If is pressed during the rinsing cycle, it immediately stops
the process.
After
flashes, the display will return to the previous display.
Q To turn off the power after use « P. GB27