Error display, Troubleshooting, Gb46 – Panasonic NCZA1 User Manual

Page 46

Advertising
background image

GB46

Error display

Display

Cause and Action

H01–H08

If this message appears on the display,
1

Turn off the espresso machine.

2

Wait until the espresso machine has cooled down completely then turn the power on again.

3

If the message is displayed again, an error has occurred. Contact an authorised service

centre for inspection.

U10

O

Brewing unit is blocked. (Technical reason)

«

Pull out the brewing unit then, using the setting function of the measuring spoon, loosen

it at the rear. To loosen, push the toothed opening on the measuring spoon onto the pin

and turn the pin completely at least 3 times. Then thoroughly rinse out the brewing unit.

U11

O

Over filled coffee powder.

«

Clean the brewing unit. (P. GB37)

U12

O

The adapter without filter cartridge is still in the water tank.

«

Remove the adapter from the water tank.

O

The water tank has overflowed or is too wet.

«

Dry the water tank and the water tank compartment thoroughly.

O

Grinding fineness set too fine or coffee powder used is too fine.

«

Clean the brewing unit.

«

Set grinding fineness coarser or use a different, coarser coffee powder.

U13

U14

O

The room temperature is too low or the espresso machine is too cold.

«

Use the espresso machine in the place above 10 °C and wait until it warms up to room

temperature.

O

The temperature inside of the espresso machine is high with continued use.
1

Wait until the espresso machine has cooled down completely then turn the power on again.

2

If the message is displayed again, an error has occurred. Contact an authorised service

centre for inspection.

Troubleshooting

(Continued)

Problem

Cause and Action

Display shows “Descaling

programme” or “Cleaning

the milk system” when

power is turned on.

O

The espresso machine is turned off without cleaning last time of use.

«

Clean the espresso machine before use. (P. GB41, GB42)

Display shows “Refill

with coffee beans”

even though there are

sufficient coffee beans.

O

If oily coffee beans are used, it may be difficult for them to flow into the grinder.

«

Feed them towards the grinder or try other types of coffee beans.

Coffee crema overflows

from the rear of the spouts.

O

Depending on the type of beans, there may be a lot of crema. (It is not a

malfunction.)

Advertising