AT&T 1485 - Manual (Page 10)

7
3 Charge the handset battery.
•
Place the handset in the remote charging stand.
The CHARGING light goes on.
• Charge the battery at least 12 hours.
4 Check for dial tone .
•
After the batteries are charged, lift the handset and
press
; you should hear a dial tone.
Handset Charger Installation
1 Connect the power cord. Be sure to
plug the cord into an electrical outlet
not controlled by a wall switch.
CHARGING Light:
on when handset is
in charging stand
2 Install the handset batter y.
Use NiCd Replacement Batter y
3301,SKU# 91076
a) Remove battery
compartment
cover by pressing
on the
indentation
and sliding
downward.
c) Place battery pack in
compartment with
the wires in the
lower left corner,
along the bottom of
the battery pack.
b) Align two holes in
plug with socket
pins, and snap the
plug into place.
d) Replace cover by slid-
ing it up into place.
91-5418-10-00_att1485_r4 2003.6.11 10:23 AM Page 7