Panasonic WV-ASC970 - - Manual (Page 25)

25
■
Default Status (LCD Display
After Login)
q Monitor number
The number of connected monitor is displayed.
w Unit number/Status
The number of connected site will be displayed.
e Camera number
The number of selected camera is displayed.
r Input number/Recorder number/Status
The numeric input, selected recorder number, or
status is displayed.
■
Blinking
In this document, grayed (greyed) areas on the LCD
illustrations mean blinking.
■
Messages Displayed on the LCD
The following are examples of LCD display after login.
Note:
• Some parts of LCD displays, described on this
document, may differ from the actual status.
● Invalid
MON CAM
0032 Unit:01 >00512
∗ MON Prohibit CAM
0001 Unit:01 00001
Blinking
MON Invalid CAM
0001 Unit:01 00001
LCD Display Descriptions
This message is displayed in the following circum-
stances.
• When you have entered a wrong user ID or pass-
word, etc.
• When you have entered a camera number or moni-
tor number, etc. that is not existing.
● Busy
• When a selected monitor is controlled by a higher-
level user, "∗" blinks on the LCD. (You cannot con-
trol the monitor.)
• When a selected camera is controlled by a higher-
level user, "∗" blinks on the LCD. (You cannot con-
trol the camera.)
• To cancel the Busy status, select another monitor,
camera, or wait until "∗" goes out.
● Prohibit
• When you have tried an operation not authorized
by the system unit, "Prohibit" is displayed on the
LCD.
• When you have forgotten to select a monitor
before selecting a camera, "Prohibit" is displayed
on the LCD.
• After a few seconds, the LCD display will return to
the default status.
∗ MON Prohibit CAM
0001 Unit:01 00001
"Busy" status is activated for a monitor.
MON Prohibit CAM∗
0001 Unit:01 00001
"Busy" status is activated for a camera.
MON Prohibit CAM
0001 Unit:01 00001
Operating Procedures with WV-CU950