CatEye CC-TR300TW [V3] - Manual (Page 9)

ENG-17
ENG
ENG-16
SSE
M1/+
SSE M2/-
LT
SSE
Starting/Stopping the measurement
Initially, the unit starts or stops measurement automatically in sync
with the bicycle motion. This is called auto-mode function.
“km/h” or “mph” flashes during measurement.
The total distance, maximum speed, maximum heart rate, and maximum
cadence are updated independently of stating/stopping measurement.
Auto-mode function
When the auto-mode is turned on ( lights up), the unit detects
the wheel spinning, and starts/stops measurement automatically.
When the auto-mode is turned off (
lights off), the unit starts/
stops measurement by using the SSE button.
* For on/off of the auto-mode, see the menu screen “Setting the auto-
mode” (page 32).
* When the transmission is stopped and Sensor signal icons , ,
are off (page 15), the main timer may not start due to speed
signal not responding.
Press the M1/+ or M2/- button to turn on the sensor signal icons
, , .
Backlight
Pressing the LT button illuminates the displays for about 3 seconds.
* Pressing any button while backlight is still on extends the illumination
for another 3 seconds.
Resetting the measurement data
To reset the measurement data (TM, DST, Lap Time, C.D. DST, etc)
and the lap data, simultaneously press the SSE button and the
M1/+ or M2/- button in the measurement screen.
* Resetting the measurement data saves the data automatically on a
file. (page 24)
* The screen will freeze for about 2 seconds after resetting; however,
all measurements are operating normally, including the elapsed time.
* The countdown setting (C.D.DST →) is returned to the manu set
value you set.
* Cannot reset for 5 seconds after pressing the LAP button.
Power-saving function
When the computer does not receive any data for 5 minutes, it will
enter the power-saving mode, in which only the date/clock is displayed.
By pressing any buttons except the AC recovers from the power-
saving mode, and the measurement screen appears. You must press
a button when the computer is in power saving mode before it will
start to measure any data.
Power-saving mode
AT icon
(or)
( S i m u l t a -
neously press)
( S i m u l t a -
neously press)
Average speed
Average heart
rate
Average cadence
Maximum
speed
Maximum
heart rate
Maximum cadence
Current speed
Heart rate
Cadence
M1/+
Date
Clock
Total time
Total distance
Calorie
Consumption
Elapsed time Trip distance
Countdown
distance
Lap
number
Lap timer
Average
lap
speed
Lap distance
M2/-
M2/-
(2 Sec.)
M2/-
Basic operation of the computer
Functions on the measurement screen
The measurement screen displays 4 different types of data, which are switched by press-
ing the M1/+ and M2/- buttons.
The display data are as follows.
Upper display data
Displays the data related to the speed.
Middle display data
Displays the data related to the heart rate.
Displays the data related to the cadence.
Lower display data
Displays the other data.
Real time lap data (on-going lap data)
* Pressing and holding the M2/- button while
displaying the lap timer switches the lap timer to
the lap distance.
Pressing it again returns to the lap timer.
* Upper and Middle display data are switched in sync together.
Switch using the M2/- button
Switch using the M1/+ button