CatEye CC-GL10 [Stealth 10] - Manual (Page 9)

9
Introduction
How to install the
unit on your bicycle
Setting up the
computer
Others
Changing the computer con-
figuration
Uploading the mea-
surement data
Setup of your
PC
How to use the
computer
Functions available on the measurement screen
Starting/Stopping measurement
Caution: Press and hold the MODE button to reset the computer before and after
measurement.
Measuring starts by resetting the computer. The unit keeps recording the
trip until it is reset. Turn off the unit when not in use.
When the GPS signal receiving icon ( ) lights up,
the unit starts/stops measurement in sync with the
bicycle motion.
Switching computer function
Pressing the MODE button switches the measurement data in the lower display, in the order
shown in the figure.
*1: When Tm exceeds about 27 hours, or Dst exceeds 999.99 km, Average Speed cannot
be measured, while displaying “.E”. Reset the data.
Backlight
When using it during night-time, the backlight always lights up.
Example: Setting of the night-time: 7:00 PM to 6:00 AM
* The night-time can be set to your needs.
For information on how to set the night-time, see “Changing the computer configuration” (page 20).
* As default, it is set to 7:00 PM to 6:00 AM.
MODE MODE
MODE MODE
MODE MODE
Tm : Elapsed Time
0:00’ 00” - 9:59’ 59”
Dst : Trip Distance
0.00 - 999.99 km [mile]
Dst 2 : Trip Distance-2
0.00 - 999.99 /
1000.0 - 9999.9 km [mile]
Av : Average Speed (*1)
0.0 - 105.9 km/h
[0.0 - 65.9 m/h]
Mx
: Maximum Speed
0.0 (3.0) - 105.9 km/h
[0.0 (2.0) - 65.9 m/h]
Odo : Total Distance
0.0 - 9999.9 /
10000 - 99999 km[mile]
Starts measurement Stops measurement
Current speed
0.0 (3.0) - 105.9 km/h
[0.0 (2.0) - 65.9 m/h]
Selected data
GPS signal
receiving icon
Clock
0:00 - 23:59
[AM1:00 - PM12:59]
PM 6:59 AM 6:00 PM 7:00 – AM 5:59
A backlight is turned on automatically