CatEye CC-ED400 [Enduro] - Manual (Page 2)

5 mm
ENDURO ENG 2 How to install the unit on your bicycle
When attaching the FlexTight™ bracket to the stem
1
Attach the bracket to the stem or handlebar
2
Install the sensor and magnet
3
Route the wire
The FlexTight™ bracket can be attached to either the stem or the handlebar, depending on how the bracket fi ts into the
bracket band.
Remove/Install
the computer
Sensor
Nylon ties
(x 7)
Magnet
Nylon ties
Nylon ties
Nylon ties
Nylon ties Handlebar
Click
While supporting it by hand,
Push it out as if lifting
the front up
Stem
Bracket
Wire
Double-sided tape
Spiral tube
Spiral tube
Bracket
Bracket
Bracket
Bracket
Double-sided tape
Double-sided tape
Pull
securely
Magnet
Spoke
Magnet
Magnet
SENSOR ZONE
Sensor
Sensor
Magnet
Sensor
Sensor
Nylon ties
Nylon ties
SENSOR
ZONE
To the
SENSOR ZONE
When attaching the FlexTight™ bracket to the handlebar
Install the sensor and magnet
The magnet passes through the
sensor zone. The clearance between the sen-
sor and magnet is 5 mm or less.
Secure the cord on the fork with the nylon ties and lead to the handle
bar along the outer cable of the bicycle by means of the spiral tube.
Caution:
Adjust the wire length so that it may not be pulled when the han-
dle is operated.
* The magnet may be in-
stalled anywhere on the
spoke if the above instal-
lation conditions are satis-
fi ed.
1
2
Pull securely
Pull securely
OK
NO!
Cut
Cut
Cut
(3/16”)