CatEye CC-TR100 - Manual (Page 20)

CC-TR100 37 36 CC-TR100
Cadence zone menu screen
MODE- 1
MODE- 2
MODE- 1
MODE- 2
Haert rate sensor ID menu screen
S/S/E
MODE- 1
MODE- 1
MODE- 1
MODE- 2
MODE- 1
MODE- 1
MODE- 1
MODE- 1
MODE- 2
MODE- 2
MODE- 2
MODE- 2 MODE- 2
MODE- 2 MODE- 2
S/S/E
+
MODE- 1 + 2
S/S/E
+
MODE- 1 + 2
• Changing the heart rate zone
Display 3 indicates the zone lower limit while Display 4 indicates the upper limit.
When MODE-1 button is pressed, the lower and upper limits flash in alternating order.
When MODE-2 button is pressed while upper/lower limit is flashing, the first digit will begin
to flash.
To change a value and shift the digit, see the illustrations below. After entering the desired
value, press the MODE-1 button to cause all the numeric characters to flash, and press the
START/STOP/ENTER button to finish the setting operation.
The default settings are shown below:
Zone 1 : Lower - 100 bpm; Upper - 120 bpm
Zone 2 : Lower - 120 bpm; Upper - 140 bpm
Zone 3 : Lower - 140 bpm; Upper - 160 bpm
Zone 4 : Lower - 160 bpm; Upper - 180 bpm
NOTE: • To change the upper or lower limits, all data must be reset to zero and the bicycle
cannot be in motion. Press MODE-1, MODE-2, and START/STOP/ENTER buttons
simultaneously to reset all data.
• Not resetting all measured data causes the “PLEASE rESEt” message to be dis-
played, making selection impossible.
• When a lower limit value greater than the upper limit value is entered, the upper
limit value is automatically adjusted to the value of the lower limit value plus one.
When a wrong upper limit value is entered, the same adjustment is made.
The range of each zone may overlap.
Select
First digit
Changing the lower
limit value
Changing the upper
limit value
Third digit
Second digit
Digit shift
First digit
Second digit
Third digit
Digit shift
Digit shift Digit shift Reset all
measurements.
Reset all
measurements.
For the basic information on how to use the
menu screen, refer to page 28.
MODE- 1
MODE- 1
On
OFF
1
2
3
4
MODE- 2
MODE- 2
S/S/E MODE- 1
Time in heart
rate zone
Lower limit
Upper limit
Zone no.
Set target Heart rate zone menu screen Select zone no.
Target setting status
(On/Off)
Heart rate zone
You can select the HR zone, check the time in zone, turn the HR target on/off, and change the
HR zone ranges.
• Checking the time in target zone
You can check the time in HR zone by pressing START/STOP/ENTER while on the menu
screen.
There are four heart rate zones. The zone number is displayed with its lower and upper
limits, time in zone, and target setting status. To switch the zone, press the MODE-2 button.
NOTE: When the computer is reset, all data for time in zones is reset to zero.
• Turning on/off the target
You can select whether or not to set a zone as a target (alert setting in range) by pressing
MODE-1.
NOTE: Targets can be set for more than one zone.
When using more than one target zone, the computer will only alert you if you are
outside ALL your target zones.