CatEye CC-TR100 - Manual (Page 22)

CC-TR100 41 40 CC-TR100
Data file menu screen
MODE- 1
MODE- 2
MODE- 1
MODE- 2
PC link menu screen
MODE- 1
5
10
30
1
MODE- 2
MODE- 2
On
OFF
S/S/E
S/S/E
For the basic information on how to use the
menu screen, refer to page 28.
Data storage
You can select the recording interval and turn the data storage on or off.
For data storage function, see “data storage function” on page 27.
NOTE: • Before selecting recording interval or turning data storage on or off, it is necessary
to stop the measurement and reset all measured data.
• Not resetting all measured data causes the “PLEASE rESEt” message to be displayed,
making selection impossible.
• Selecting recording interval
Specify the interval of memory recording in seconds.
Display 1 indicates the timing in seconds, and Display-5 indicates how much data can be
stored with the remaining memory, in the specified memory interval.
The maximum data storage times are listed below with their respective intervals:
1 second intervals: .......... Maximum 5 hours
5 seconds: ....................... Max. 25 hours
10 seconds: ..................... Max. 50 hours
30 seconds: ..................... Max. 150 hours
• Turning data storage on/off
When data storage is on, data files can be created, and the icon on the main display will
light up.
NOTE: • When the remaining memory is 0%, or 99 files have already been stored, further
data storage cannot be performed.
• When the remaining memory indicates 0% while the data storage is in progress, a
data file is created at that point. Measurement after that is switched to the regular
measurement from the data storage. When the regular measurement is performed
even though the data storage is turned on, the
icon flashes.
Select recording interval Turn data storage on or off
Select
Memory recording interval
Remaining hours of
storage available
Data storage(On/Off)
Data storage menu screen
S/S/E
+
MODE- 1
S/S/E
+
MODE- 1
S/S/E
+
MODE- 1
MODE- 1 or MODE- 2
S/S/E
• Deleting a data file
Display the data file number that you wish to delete and press MODE-1 and START/STOP/
ENTER buttons simultaneously. Only the displayed file will be deleted.
NOTE: When a data file is deleted, the numbering sequence of the remaining files is ad-
vanced.
• Deleting all data files
Display “Data file” on the menu screen, and press the MODE-1 and START/STOP/ENTER
buttons simultaneously to delete all data files.
A message will appear to confirm whether or not you wish to delete all data files. To delete
them press MODE-1 and START/STOP/ENTER buttons simultaneously again.
NOTE: To cancel deleting all data files, simply press MODE-1 or MODE-2.
Deleting all data files
M e s s a g e t o c o n f i r m
deletion of all data files.
Data file menu screen
Cancel
Data file check screen
Deleting a data file