Merrychef eikon e4s - Manual (Page 9)

Service & Parts Manual original Instructions
Part Number 32Z3871 US
Issue 3
9
PR
ODUC
T
DE
T
AILS
DANGER!
THIS APPLIANCE MUST BE EARTHED.
FAILURE TO DO SO MAY RESULT IN
ELECTRIC SHOCK AND DEATH.
For all cord connected appliances:
GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event of an
electrical short circuit, grounding reduces the risk of
electric shock by providing an escape wire for the electric
current. This appliance is equipped with a cord having
a grounding wire with a grounding plug. The plug must
be plugged into an outlet that is properly installed and
grounded.
WARNING - Improper use of the grounding can result in the
risk of electric shock.
Consult a qualifi ed electrician or Serviceman if the
grounding instructions are not completely understood
or if doubt exists as to whether the appliance is properly
grounded.
Do not use an extension cord. If the power supply cord is
too short, have a qualifi ed electrician or serviceman install
an outlet near the appliance.
For a permanently connected appliance:
GROUNDING INSTRUCTIONS
This appliance must be connected to a grounded, metallic,
permanent wiring system, or an equipment grounding
conductor should be run with the circuit conductors and
connected to the equipment grounding terminal or lead
on the appliance.
6 ELECTRICAL INSTALLATION
IN CASE OF RADIO OR TELEVISION INTERFERENCE
This equipment generates and uses radio frequency
energy and if not installed and operated correctly, in
strict accordance with the manufacturer’s instructions,
may cause harmful interference to authorized radio
communication services.
This product complies with the relevant requirements
of CFR 47 Ch.1 Part 18, which are designed to provide
reasonable protection against such interference. However,
there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user
is encouraged to try and correct the interference by one or
more of the following measures:
1) Re-orientate the receiving antenna.
2) Relocate the microwave with respect to the receiver.
3) Plug the microwave into a diff erent outlet so that the
receiver and microwave are on diff erent branch circuits.
If necessary the user should consult the dealer or an
experienced radio/television technician for additional
suggestions.
Note: Modifi cations should only be carried out by the
manufacturer or authorized representative to ensure
continuing conformance.
This device complies with Part 18 of the FCC rules.
POWER SUPPLY REQUIREMENTS
This appliance should be connected to a suitable
electricity supply which can cope with the switching
on surge that occurs with certain types of catering
equipment, including microwaves. Because of this
requirement, ,we strongly recommend that a separate,
suitably rated supply is installed for the oven.
The supply for the oven should be fi tted with a type “C” or
Time Delay circuit breaker rated at:
30 AMP for 208V electrical supply (2P+GND)
30 AMP for 240V electrical supply (2P+GND)
If the oven is hard wired to the supply, a double-pole
isolator switch with a contact gap of at least 1/8 inch
(3mm) should be fi tted.