Pitco Frialator 26 Gas Fryer - Manual (Page 5)

INSTALLATIONS
L20-078 Rev. 6 (05/11) 5
1 INSTALLATION
1.1 CHECKING YOUR NEW APPLIANCE
Your new Pitco appliance has been carefully packed into one crate. Every effort has been made to
ensure that it is delivered to you in perfect condition. As you unpack your new appliance, inspect each
of the pieces for damage. If something is damaged, DO NOT sign the bill of lading. Contact the
shipper immediately; the shipper is only responsible for 15 days after delivery. As you unpack the
appliance and its accessories be careful to keep the weight of the appliance evenly distributed.
Locate your Pitco model number and serial number on the inner door of the appliance and the find
the date purchased. Write this information on the front cover of this manual for future reference.
If you have completed the above steps that are applicable to the appliance you purchased, the
appliance is now ready to be installed. Although it may be possible for you to install and set up your
new appliance, it is STRONGLY recommended that you have this done by qualified professionals. A
qualified professional will ensure that the installation is safe and meets local building and fire codes.
1.2 INSTALLATION CLEARANCES
The clearances shown below are for combustible and non-combustible installations and will allow for
safe and proper operation of your appliance.
In addition to the above clearances there must also be at least 16 inches (40.64cm) of aisle space in
front of the unit.
Combustible Construction Non Combustible Construction
Inches (centimeters) Inches (centimeters)
Back 6.0" (15.24cm) 0.0" (0.0cm)
Sides 6.0" (15.24cm) 0.0" (0.0cm)
Counter 6.0" (15.24cm) 6.0" (15.24cm)
WARNING
DO NOT sit or stand on this appliance. The appliance’s front panel, tank,
splash back, tank cover, work shelf, drain board is not a step. Serious
injury could result from slipping, falling or contact with hot liquids.
WARNING
DO NOT install this appliance next
to a water cooker without an
appropriate splash guard. A splash
over of water into the hot oil may
cause a flash fire.
WARNING
DO NOT obstruct the flow of ventilation, or air openings
around the appliance. Adequate clearance around the
appliance is necessary for servicing and proper
component ventilation. Ensure that you meet the
minimum clearance requirements specified in this manual.
CAUTION
To prevent equipment damage and/or personal injury, do not tilt the appliance onto any
two of its casters or legs, or pull the appliance by the splash back.