Power Soak 37099 PS-201 Owner's Manual - Manual (Page 18)

14
The Power Soak machine requires minimal, routine preventive
maintenance. As such, the following should be done on a routine basis to
ensure that the machine remains reliable:
Daily
Clean the liquid level sensors. These sensors are located on the side walls
of the wash and sanitizer tanks. They are the white plastic discs with metal
centers. Clean the sensor faces thoroughly. If cleaned regularly, a
washcloth and soapy water are all that is required.
Monthly
IMPORTANT: Turn off the power to the unit at the main
breaker prior to performing the following task!
Clean the pump motor fan shroud with a damp, soapy rag. The motor
shroud is the "vented" cover located at the end of the motor (closest to the
control panel). This will prevent grease and dust from accumulating in the
cover's openings, which can obstruct the airflow that cools the motor.
De-lime the wash sink. Simply add a de-liming agent to a sink of warm,
fresh water and run the system overnight.
Ask a chemical sales representative to recommend a specific de-liming
agent.
This completes the list of maintenance procedures that will need to be
performed on the Power Soak machine. It is not necessary to grease the
motor bearings, as they are permanently sealed. If you there any questions
regarding the preventive maintenance procedures, please contact the
factory at 800-444-9624.
If the liquid level sensors are not cleaned regularly, the
machine may fail to operate; or it may be possible to
run it without water, which will cause serious damage to
the unit.