Power Soak 37099 PS-201 Owner's Manual - Manual (Page 21)

17
Wash Pump/Heater Will not Operate
After reviewing the status of the control panel LED’s, there is still an
operating problem, refer to the following troubleshooting guidelines:
• Check the main electrical power breaker for the Power Soak system
to see that it is in the “ON” position.
• See that the wash sink is filled to the waterline.
• Check the liquid level sensors and see that they are clean and free
of any debris or grease. The liquid level sensors are located on the
side walls of the wash and sanitizer sinks (the white plastic disc with
a metal center).
If the above trouble shooting procedures do not correct the problem,
contact Power Soak Systems, Inc., or an authorized service agency at 800-
444-9624.