Power Soak 37099 PS-201 Owner's Manual - Manual (Page 22)

18
Authorized Service Agency Section
Hazard to untrained or unauthorized personnel.
The following procedures are provided for use only by
an authorized service agency. No facility owner,
manager, employee or other unauthorized person
should attempt to perform any of these procedures. To
obtain the name of a recommended service agent,
please call the Power Soak Service Department at
800-444-9624.
When performing troubleshooting procedures, the
authorized service agency will need to open the Power
Soak machine’s main electrical enclosure.
Properly close the control panel before reconnecting
the circuits.
Explanation of LED Sequence
The control enclosure of the Power Soak machine will need to be opened
to verify the proper operation of the operating logic. This will require
examination of the LED’s on the programming module. The Universal
Programming Module (UPM) is mounted to the inside of the control
enclosure cover.
The UPM has six LEDs mounted on its top edge. The meaning of each
LED is as follows, starting from the right-most LED:
#1 - Power On
#2 - Error Code
#3 - Wash Tank Low-level Sensor
#4 - Wash Tank Upper-level Sensor
#5 - Sanitizer Tank Low-level Sensor
#6 - Sanitizer Tank Upper-level Sensor