Vaddio CeilingVIEW HD HideAway - Manual (Page 10)

CeilingVIEW HD HideAway Manual
CeilingVIEW HD HideAway Manual, Document Number 342-0289 Rev. B Page 10 of 24
P. Attach the Lower Décor Plate to the bottom of the Camera Platform with three (3) white pan head screws.
Q. Attachment of the Ceiling Trim Ring Assembly to the CeilingVIEW HD HideAway Motorized Back Box
Assembly:
I. The IR Sensor Circuit Board is connected by a four (4) conductor Phoenix Connector on a cable that is
located on the bottom rear of the CeilingVIEW HD HideAway Motorized Back Box Assembly. Attach
the four (4) conductor Phoenix Connector to the IR Sensor Circuit Board and carefully feed the excess
cable back into the CeilingVIEW HD HideAway Motorized Back Box Assembly.
II. Align and attach the Ceiling Trim Ring Assembly to the CeilingVIEW HD HideAway Motorized Back Box
Assembly with five (5) white countersunk screws.
Important Note: As the Ceiling Trim Ring Assembly is attached to the CeilingVIEW HD
HideAway back box Assembly, do not let the Ceiling Trim Ring Assembly hang by the IR Sensor
Cable or put tension on the IR Sensor Cable, damage may occur! Provide continuous support of
the Ceiling Trim Ring Assembly while installing the five (5) countersunk screws until all five (5)
screws are installed and tightened firmly and evenly to prevent warping of the Ceiling Trim Ring
Assembly.
Camera mounting
screw locations
IR Sensor Circuit
Board Cable
Figure 16: View of Camera Lift Platform from below ceiling with
IR Sensor Circuit Board Cable exposed
Figure 15: Vaddio ClearVIEW HD-18 PTZ
HD Camera mounted on the Camera Lift
Platform
Figure 17:
View of Ceiling Trim Ring
Assembly and Lower Décor
Plate attached to the
CeilingVIEW HD HideAway
Motorized Back Box Assembly