Vaddio CeilingVIEW HD HideAway - Manual (Page 15)

CeilingVIEW HD HideAway Manual
CeilingVIEW HD HideAway Manual, Document Number 342-0289 Rev. B Page 15 of 24
Instructions for Calibrating; Setting the Upper and Lower Lift Stops:
A. Place the CeilingVIEW HD HideAway into the Calibration Mode: With the Blue Power LED on steady in
the CeilingVIEW HD HideAway Trim Ring Assembly, press and hold the Calibration push button on the IR
Circuit Board in the Trim Ring Assembly until Blue Power light is flashing.
Note: The order of the three holes in the Trim Ring Assembly is (from left to right):
1) Blue Power LED,
2) IR Sensor and
3) Calibration Switch. The Calibration Switch can be activated using a small screw driver.
B. Using the Vaddio IR Remote Commander (which is included with all models of Vaddio ClearVIEW HD PTZ
Cameras), press the following buttons to move the lift Up or Down (see Figure 26):
▲ Pan-Tilt Up Arrow: Moves the lift up quickly
► Pan-Tilt Right Arrow: Moves the lift up slowly
▼ Pan-Tilt Down Arrow: Moves the lift down quickly
◄ Pan-Tilt Left Arrow: Moves the lift down slowly
C. Setting the Lower Lift Stop: Move the lift downward and align the Upper White Décor Plate (the white plate
above the camera) with the Ceiling Trim Ring (see Figure 24).
D. When the Upper White Décor Plate is aligned with the Ceiling Trim Ring, save the Lower Lift Position setting
by pressing the Back Light button on the IR Remote Control.
E. Setting the Upper Lift Stop: Move the lift upward and align the Lower White Décor Plate (the white plate
below the camera) with the Ceiling Trim Ring (see Figure 25).
F. When the Lower White Décor Plate is aligned with the Ceiling Trim Ring, save the Upper Lift Position setting
by pressing the Data Screen button on the IR Remote Control.
Calibration
Switch Blue Power
LED
Figure 23: CeilingVIEW HD HideAway Ceiling Trim Ring/Calibration Switch Location