Vaddio CeilingVIEW HD HideAway - Manual (Page 8)

CeilingVIEW HD HideAway Manual
CeilingVIEW HD HideAway Manual, Document Number 342-0289 Rev. B Page 8 of 24
F. When the Ceiling Tile Brace has been placed in the desired position, trace the outline of the center opening
of the Ceiling Tile Brace on the suspended ceiling tile (see Figure 5).
G. Using a sharp utility knife, score the marked outline on the suspended ceiling tile. Carefully cut out the
marked outline. Note: When cutting out the opening, cut out each of the four (4) corners of the outline to
make the opening square (see Figure 6).
H. Re-install the suspended ceiling tile that has the cutout opening back into the ceiling grid. Place the Ceiling
Tile Brace on top of the tile and align it to the cutout opening (see Figure 7).
I. Provide and install four (4) individual support cables for connection to the Ceiling Tile Brace (see Figure 12)
Attach each of the support cables for the CeilingVIEW HD HideAway System to the appropriate building
structure support. Note: The photo examples (see Figures 12 and 13) show the use of cable clamps to
secure the cable to the ceiling structure and the turnbuckles.
Note: Use of a turnbuckle for each of the four (4) individual support cables is highly recommended and will
make it easier to adjust the cable tension on the Ceiling Tile Brace.
J. Attach the four-individual support cables to the Ceiling Tile Brace utilizing the provided holes in the four (4)
outer corners of the Ceiling Tile Brace (see Figure 13).
K. Install the turnbuckles on each of the four (4) corners of the Ceiling Tile Brace. Tighten each cable to
provide equal tension to support the Ceiling Tile Brace (without lifting the Ceiling Tile Brace off of the ceiling
tile) and secure each of the four (4) cables.
Figure 12:
Support cable attached to building structure to
support the weight of the enclosure
Figure 13:
Outline of Ceiling Tile Brace opening with
four (4) turnbuckles attached to the brace