Vaddio CeilingVIEW HD HideAway - Manual (Page 9)

CeilingVIEW HD HideAway Manual
CeilingVIEW HD HideAway Manual, Document Number 342-0289 Rev. B Page 9 of 24
L. Carefully lower and place the CeilingVIEW HD HideAway Motorized Back Box Assembly into the Ceiling Tile
Brace opening.
M. Check and verify that each of the four (4) individual support cables are all equal in tension and that the
weight of the CeilingVIEW HD HideAway is supported mainly by the cables and not by the suspended ceiling
tile. This can be verified by looking carefully at the ceiling tile below the ceiling and checking for signs of
curving or bowing of the ceiling tile (compare to other suspended ceiling tiles near your installation area). If it
appears that the ceiling tile is bowing, increase the tension in equal minimal amounts for each of the four-
individual support cables and check to see if the bowing decreases. It is important to have some weight on
the tile (approximately 25-50% of the total weight). Do not adjust the tension so that any corner or the entire
Ceiling Tile Brace is completely off the suspended ceiling tile.
N. Carefully set the Vaddio CeilingVIEW HD PTZ Camera on the Camera Lift Platform inside the CeilingVIEW
HD HideAway Motorized Back Box Assembly. Connect the Gray RJ 45 jack to the RS-232 Control IN port
on the Vaddio CeilingVIEW HD PTZ Camera. Connect the Black RJ-45 jack to the EZ-Power/Video port on
the Vaddio CeilingVIEW HD PTZ Camera.
Note: Do not connect the Black RJ-45 EZ Power/Video Cable into the RS-232 Control IN Port or
damage may occur to the Vaddio CeilingVIEW HD PTZ Camera.
O. Align the Vaddio CeilingVIEW HD PTZ Camera with the mounting holes in the Camera Lift Platform and
insert the camera mounting screws. Check alignment of the Vaddio CeilingVIEW HD PTZ Camera to the
mounting bracket and tighten the camera mounting screws (see Figures 15 and 16).
Figure 14:
CeilingVIEW HD HideAway
Motorized Back Box Assembly
inserted into the Ceiling Tile Brace