Command list, Visca1) rs-232c commands, Visca – Vaddio EVI-D80D90 Tech User Manual

Page 21: Rs-232c commands, Overview of visca

Advertising
background image

21

Command List

VISCA

1)

RS-232C

Commands

Use of RS-232C control software which has been

developed based upon this command list may cause

malfunction or damage to hardware and software. Sony

Corporation is not liable for any such damage.

Overview of VISCA

In VISCA, the device producing the commands, for

example, a computer, is called the controller, while the

device receiving the commands, such as an

EVI-D80N/D80P/D90N/D90P, is called the peripheral

device. The EVI-D80N/D80P/D90N/D90P serves as a

peripheral device in VISCA. In VISCA, up to seven

peripheral devices like the EVI-D80N/D80P/D90N/

D90P can be connected to one controller using

communication conforming to the RS-232C standard.

The parameters of RS-232C are as follows.

Communication speed: 9,600 bps/38,400 bps

Data bits : 8

Start bit : 1

Stop bit : 1

Non parity

Flow control using XON/XOFF and RTS/CTS, etc., is

not supported.

Peripheral devices are connected in a daisy chain. As

shown in Fig. 1, the actual internal connection is a one-

direction ring, so that messages return to the controller

via the peripheral devices. The devices on the network

are assigned addresses.

The address of the controller is fixed at 0. The

addresses of the peripheral devices are 1, 2, 3 ... in

order, starting from the one nearest the controller. The

address of the peripheral device is set by sending

address commands during the initialization of the

network.

The VISCA devices each have a VISCA IN and VISCA

OUT connector.

Set the DSR input (the DTR output of the controller) of

VISCA IN to H when controlling VISCA equipment

from the controller.

Fig. 1 VISCA network configuration

.......................................................................................................................................................................................................................................................

1) VISCA is a protocol which controls consumer camcorders developed by Sony. “VISCA” is a trademark of Sony Corporation.

VISCA Equipment

IN

OUT

IN

OUT

IN

OUT

VISCA Controller

Advertising