Vaddio WallVIEW HD-22 and HD-30 DVI-HDMI - Manual (Page 11)

WallVIEW HD-22 and HD-30 SR Systems
WallVIEW HD-22 and HD-30 DVI/HDMI SR Cameras Systems - Document Number 342-0644 Rev A Page 11 of 24
Step 2: System Wiring
Follow the sample wiring diagrams for connecting the Cat-5 cables to the camera and Quick-Connect DVI/HDMI
SR Interface. Additional diagrams are available on the Vaddio website.
Connect the camera side as follows:
 Connect the Power/Video Cat-5 to the EZ POWER HD VIDEO RJ-45 jack on the back of the camera.
 Connect the RS-232 Control Cat-5 to the RS-232 IR OUT RJ-45 on the camera.
Connect the Quick-Connect SR side as follows:
 Connect the Power/Video Cat-5 to the EZCAMERA POWER & HD VIDEO RJ-45 jack.
 Connect the RS-232 Cat-5 cable to the RS-232 ‘TO CAMERA’ RJ-45 jack and connect the controller, or
console to the RS-232 INPUT.
 The controller can be routed directly to the camera if preferred. For IR Forwarding, the RS-232 cable must be
routed through the Quick-Connect SR in order to operate correctly (see pin-out section)
 Connect the video outputs (HD-YPbPr or HDMI/DVI) to the desired video console or display.
Note: Please check all Cat-5 cables for continuity in advance of final connection. Plugging the
POWER/VIDEO Cat-5 cable into the wrong RJ-45 may cause damage to the camera system and
void the warranty!
Step 3: Secure the Camera To the CONCEAL Wall Mount Bracket
After all cables are attached to the camera, slide the camera back onto mount and insert the two 1/4”-20 screws
into the camera through the two-screw slots in the bottom of the mount. Note: Be sure to align each side of the
camera evenly for the best fit prior to tightening down the mounting screws.
Step 4: Install the CONCEAL Lower Cover Plate
Attach the CONCEAL lower cover plate. Slide the lower cover plate from front of the mounting bracket toward the
rear of the bracket. The two (2) rear locking tabs will need to be guided into position first and will lock in place as
the lower cover plate is pushed toward the rear of the mounting bracket. The two (2) front tabs will engage as the
cover is pushed back into place.
Step 5: Install the CONCEAL Rear Camera Cover
Install the CONCEAL rear camera cover on the mounting bracket with the supplied screw.
NOTE (One more time!): Please verify that the Cat-5 cables are plugged in correctly. Plugging the
wrong cable into the wrong jack may cause confounding bewilderment (in general).
Step 6: Connect System Power
Connect the 24 VDC power supply to the Quick-Connect DVI/HDMI SR Interface and the AC plug into an AC
outlet. The Quick-Connect will power the camera via the Power/Video Cat-5 cable. The camera will “Home” to a
centered position (or stored preset home position if one is set) and will output video when it has completely
booted up. The WallVIEW is now ready for control information from a controller or IR Remote Commander.
CONCEAL Lower Cover Plate
with Locking Tabs
CONCEAL Lower Cover
Plate locked in place
CONCEAL Rear Camera Cover
Completed CONCEAL Wall Mount
Camera Bracket Installation