Vaddio WallVIEW HD-22 and HD-30 DVI-HDMI - Manual (Page 7)

WallVIEW HD-22 and HD-30 SR Systems
WallVIEW HD-22 and HD-30 DVI/HDMI SR Cameras Systems - Document Number 342-0644 Rev A Page 7 of 24
Rear Panel Connections with Feature Call-outs
Image: WallVIEW HD-22/30 SR Camera System
5) RS-232 IN & IR Out:
The RS-232 port accepts modified VISCA protocol for camera control, as well as transmits IR signaling received
by the IR receivers, which can be transmitted to third party remotes.
6) Dip Switch Settings:
Settings for IR remote, baud rate and image flip can be configured on these switches. See the Switch Settings
page for additional information.
7) HD Video Select:
A rotary switch allows the user to choose the component HD output video resolution and format. See the Switch
Settings page for additional information.
 HD Resolution Note: When changing the resolution of the camera, the camera should be power-
cycled after the change.
8) 12 VDC Input:
Power input for the standard 12 VDC, 3.0 Amp power supply for the HD-22 and HD-30. The 12 VDC power
supply is only used with the standalone cameras, but not with the WallVIEW systems).
9) HDMI Output:
The HDMI output feeds out HD digital video only (no copy protect or device communication is required). The
HDMI output is optimized for high definition video signals.
10) YPbPr Output:
Component HD video (YPbPr) is output through the DE-15 connector. YPbPr and HDMI signals have
simultaneous output. Limited SD resolutions are supported.
11) EZ Power HD Video Port:
This RJ-45 connector is used with the Quick-Connect SR type interfaces to supply power and return HSDS
(differential) video from the camera. Please mark and test cables for voltage. prior to connection.
12) Slot for Optional Cards:
Optional slot cards can be plugged into the rear panel slot of the HD-22 and HD-30 cameras. The HD-SDI Slot
Card is sold separately and the EZIM CCU Slot Card is available in the CCU system package.
⑥
⑤
⑧
⑦
⑩
⑨
⑫
⑪