Vaddio WideSHOT WallVIEW SR - Manual (Page 8)

WideSHOT WallVIEW SR
WideSHOT WallVIEW SR System Document Number 342-0695 Rev B Page 8 of 20
Q UICK -C ONNECT SR I NTERFACE
Image: Rear Panel with Feature Call-outs
1) Power Input:
5.5mm OD x 2.5mm ID coaxial connector for the provided PowerRite 24 VDC, 2.0 Amp power supply.
2) EZCamera Power & HD Video:
A single Cat-5 connection between the EZCAMERA POWER & HD VIDEO RJ-45 connector and the camera’s
EZ Power HD Video Port on the HD-19 camera extends power and video. Power is fed to the camera and HSDS
video is returned from the camera on the same Cat-5.
3) HD Video Output:
DE-15 connector outputs the YPbPr analog component HD video, which was extended from the camera over
Cat-5 cable. SD video resolutions (Y/C and CVBS formats) are not supported by the Quick-Connect SR
Interface, however analog component SD video is supported.
4) IR Output:
With the IR pass-thru turned ON (see camera dip switch settings), IR from third-party IR remote controls can be
sent through the WideSHOT camera to third-party equipment, such as hardware videoconferencing codecs. IR
can be used as either modulated (through the air) or non-modulated (wired) signals).
5) RS-232 Input & Output Jacks:
These RJ-45 connectors allow an external controller to route through the Quick-Connect SR for ease of cabling.
F IRST T IME S ET - UP
The WideSHOT was designed to be very easy to use and operate. There is documentation at the back of this
manual for pin-outs of the connectors on the Quick-Connect SR Interface and WideSHOT HD camera.
Before Installing:
 Choose the camera mounting location by paying close attention to camera viewing angles, lighting conditions,
possible line of site obstructions, and checking for in-wall obstructions where the camera is to be mounted.
Always pick a mounting location that will optimize the performance of the camera.
 The Thin Profile Wall Mount for the WideSHOT can be mounted directly to a 1-gang wall box or can be
mounted using only dry wall anchors.
 For Power/Video and RS-232 signals, use standard Cat-5 cable (568B termination and real RJ-45
connectors) from the EZ-POWER VIDEO and RS-232 ports on the back of the WideSHOT camera to the
Quick-Connect SR Interface. The EZ-POWER VIDEO jack on the camera is highlighted
red as a reminder
that there is 24 VDC power on that Cat-5 cable.
① ② ④ ⑤ ③